Report No. 317-F-11-5INSTALLATION AND OPERATION MANUALDo not store or use gasoline or other flammable vapors or liquids in the vicinity of this or any
10 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE14.0 CHECKING THE BURNERThere are no imitation fuel bed components, such as logs or ro
11NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE16.0 CHECKING THE GAS CONNECTIONSTurn on gas supply and test for gas leaks using a gas leak test
12 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE18.0 SPARK GAPFigure 8 - Proper Spark Gap1/8" to 3/16" Spark Gap19.0 BRIEFING THE CUST
13 WARNING Any change to this heater or its controls can be dangerous. WARNING No adjustments are to be made to the ODS pilot
14 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE21.0 CATALYSTS WARNING Do not block the catalysts or the appliance outlet grill. Blockage m
15FOR YOUR SAFETY READ BEFORE LIGHTINGWARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAYRESULT CAUSING PROPERTY DAMAGE,
1624.0 TROUBLESHOOTING GUIDEPROBLEM CORRECTIVE ACTIONIgniter sparks but pilot does not light • No gas to Pilot, check the gas line connections.• Ai
17WARNINGCLEARANCES FROMCOMBUSTIBLEMATERIALSF860041/AThe following clearances must be maintained at all times.Failure to do so may result in the risk
1826.0 POSITIONING OF FIELD REMOVABLE PARTSGlass Door Removal: Remove the four (4) screws indicated, then lift door off.Figure 12 WARNING Failure
19NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE27.0 SPECIFICATIONSX-FIRE-WIDESCREEN Surround KitsCat. No. Model Description Ship. Wt. Ship. Volu
2• Children and adults should be alerted to the hazard of high surface temperature and should stay away to avoid burns or clothing ignition.• Young
20Printed in U.S.A. © 2008 Lennox Hearth ProductsP/N 506023-05 REV. A 11/2008Lennox Hearth Products reserves the right to make changes at any time,
32.0 GENERAL INFORMATIONThis appliance is a high efficiency, unvented, flame effect gas heater. It provides radiant and convected warmth both efficientl
46.0 BURN-IN PERIODOn initial light up of a new appliance, the ‘newness’ will burn off within the first few hours of operation. During this period some
58.0 COMBUSTION AND VENTILATION AIRThis heater shall not be installed in a confined space or unusually tight construction unless provisions are provide
69.0 SITE REQUIREMENTSThis appliance is designed to be wall-hung. Do not recess any part of the appliance into the wall.This appliance may be installe
7Non-concealed gas connections may be made using the entry points on the base of the firebox. A concealed gas connection may be made using the knockout
8 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALEFigure 3 - Wall Fixing TemplateFPOAfter having selected the final mounting position of the applian
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE9It is recommended that the burner height, where possible, should be approximately 4 ft
Comments to this Manuals