Lennox-hearth H6963 User Manual download pdf

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

REFLECTIONS TELEVISION

REPLACEMENT KIT

HEARTH PRODUCTS

KITS AND ACCESSORIES

INSTALLATION INSTRUCTIONS FOR THE REFLECTIONS ELECTRIC FIREPLACE

TELEVISION REPLACEMENT KIT (NUMBER: H6963)

P/N 506019-19

REV. N/C 01/2008

REPLACEMENT INSTRUCTIONS

Removal Of The Existing TV From The Reflections Electric Fireplace

Step 1. Disconnect the electrical power to the fireplace.

Step 2. Remove the doors from the fireplace.

Step 3. See

Figure 1

for the location of the door track and remove it.

Keep the two (2) door clips and screws to be used again upon re-

assembly.

Figure 1

Door

Track

Step 4. Remove the reflective glass. To access the logs, grate embers

and lights, the glass panel needs to be removed. For an illustration of

the glass panel installation, (refer to

Figure 8, on page 4 )

First sweep the screens inward and tie up and out of the way. The glass

is not secured by any fasteners. The back rests on two insulated tabs and

the front is hooked behind a lip.

CAUTION: WHEN REMOVING THE GLASS, DO NOT LET THE BACK

OF THE PANEL SLIP OFF OF THE INSULATED TABS IN THE BACK.

THIS COULD ALLOW THE GLASS TO DROP INTO THE REFRACTORY

PANELS OR LOGS AND BREAK THEM.

The lower front corners of the glass are exposed to provide a place

to grip the glass panel. Grip the corners firmly; lift the panel back

and up against the top of the unit.

Disengage the glass from behind the front lip and rotate the front

upwards. Slide one hand under the glass and support the panel.

Draw the glass out of the unit and set it carefully aside.

Glass Information

• This unit will not operate properly with missing or broken glass.

• Do not strike or slam the glass.

• Do not use abrasive cleaners to clean the glass.

• This appliance uses tempered glass. Replacement of the glass as

supplied by the manufacturer should be done by a qualified service

technician.

Step 5. Remove the Logs.

Step 6. Remove the Grate.

Step 7. Remove the Ember Bed.

Step 8. Disconnect and label the video and audio cables from the TV and

remove the IR module.

Step 9. Locate the two locking screws that secure the television

assembly and remove them (

see Figure 2

Figure 2

Locking Screw

Latch

Rod

Step 10. Press upwards on the latching rods to free the television

assembly. Once free, the assembly will rotate down to a vertical position

hanging from the screen rods (

refer to Figure 3

1 2 3 4

Summary of Contents

Page 1 - KITS AND ACCESSORIES

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.1REFLECTIONS TELEVISIONREPLACEMENT KITHEARTH PRODUCTSKITS AND ACCESSORIESINSTALLATION INSTRUCTIONS FOR

Page 2

2NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.Figure 3CAUTION: THE TELEVISION ASSEMBLY IS HEAVY. PLEASE CLEARTHE AREA IN FRONT OF THE FIREPLACE B

Page 3 - Grate Bracket

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.3Step 2. Hook the television assembly ontothe screen rod pins and let the unit hang inposition. Plug

Page 4

Comments to this Manuals

No comments

Lennox-hearth H6963 User Manual

Browse online or download User Manual for Kiln Lennox-hearth H6963. Lennox Hearth H6963 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Kiln Lennox-hearth H6963