
INSTALLATION AND OPERATION MANUAL WARNINGS• Hot! Do not touch! The glass and surfaces of this appliance will be hot during operation and wil
10NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.A positive flue connection is providing a seal between the vent pipe or liner and the existing fir
11Fireplace and Chimney RequirementsThis appliance must only be installed in a zero clearance factory-built fireplace using 6” (152mm) stainless s
12Place the insert into the fireplace, making sure to center it side to side. Slide the insert in until the surround mounts are approximately 1/2” (13
13NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.Be sure to clean plated accessories with a household type cleaner and a very soft cloth
14NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. WARNINGSThe blower must be plugged directly into a properly grounded three-prong r
15Recent developments in wood-burning technology have made wood-burn-ing a cleaner and more convenient way to heat your home. Overall efficiency in a w
16MAINTENANCEDOOR HINGES: If door hinges need lubricating, use an anti-seize com-pound (never use oil) available from your Lennox Hearth Products dea
17Problem SolutionPOOR DRAFT: Extend chimney in length or have the chimney realigned to the proper size flue. Oversized chimneys normally have po
18DO NOT: Install or operate this fireplace insert before reading this manual. DO NOT: Close the draft beyond the point at which the flames are com
19FRONT DOOR PARTS LISTItem # Cat. No. Description1 H5639 Door Rope Kit, 7/8” Dia. (6’ 2”)2 H5629 Upper Hinge Pin3 H5626 Upper Hinge Pin E-Clip4 H5628
2CONGRATULATIONS!When you purchased your new wood-burning fireplace insert, you joined the ranks of thousands of individuals whose answer to their home
20NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.333436364546473737354044403838384138383841383842383838384238383939433939REPLACEMENT PARTS - MODE
21NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.71312345681234591081411671216291715321819REPLACEMENT PARTS - MODELS C210, CA210 AND SWI210Door P
22Product Reference InformationCat. No. Description Ship. WeightShip. VolumeH7891 C210T-B, Insert / Traditional Black Door / Nickel Nameplate427 lb. 1
23SAFETY / LISTING LABEL - MODELS C210, CA210 AND SWI2102011 2012 2013
24Lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to disco
31. When this room heater is not properly installed, a house fire may result. To reduce the risk of fire, follow the installation instructions. Cont
4This manual describes the installation and operation of these non-catalytic wood heaters. These heaters meet the U.S. Environmental Protection Agenc
5Dry, seasoned wood is that which has been cut, split and allowed to dry under a covered area where air is free to flow and circulate under and around
6NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.CAUTION: Wear gloves during brick installation in case of sharp edges behind the fireplace insert.
7NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.C/A210SWI210ZC FireplaceUL 127Masonry FireplaceUBC Chapter 37Depth Min. 12-1/2” (318mm) 12-1/2” (
8The hearth and/or floor protection must be a thermally rated non-com-bustible hearth/floor protector meeting or exceeding a thermal rating of k=.84 or
9CHIMNEY REQUIREMENTSThis appliance is approved for use in a masonry fireplace built to UBC Chapter 37 or equivalent with a minimum 26” (660 mm) openin
Comments to this Manuals